Netapp CABLE FC 2m LC/LC Multi-Mode OM4

FS

Name: FS.COM GmbH

Anschrift: Röntgenstraße 18, 85757 Karlsfeld, Deutschland

Telefon: +49 (0) 8165 4099 260

E-Mail-Adresse: legal@FS.com

Electrostatic discharge (ESD):

Use ESD wrist straps and work in an ESD-protected environment.

Protection from moisture:

Do not install cables in areas exposed to moisture or water; use special water and moisture resistant cables in such environments.

Temperature protection and ventilation:

Install cables in areas that do not exceed the manufacturer's recommended temperature and load limits. Avoid running cables in areas of direct sunlight or near heat sources.

Electrical Safety:

When installing cables, ensure proper grounding to prevent electrical interference and damage to connected equipment. Avoid laying data cables and power cables in parallel to reduce signal interference.

Cleaning and maintenance:

Shielding should be properly grounded, particularly over long cable runs.

Assembly and disassembly:

Lay cables so that they are not kinked, twisted or pulled over sharp edges. Observe the manufacturer's minimum bending radius. Secure cables with cable ties or clips to avoid tripping hazards and ensure a neat installation.

Handling:

Label cables to make them easy to identify, especially in complex network infrastructures. Use cable management systems to avoid confusion and mix-ups. Do not pull or overstretch cables as this can damage the conductors inside. Adhere to the maximum pulling force and bend radii specified by the manufacturer. Use shielded cables (e.g. S/FTP cables) in environments with a high risk of electromagnetic interference.